Organic waste liquid incinerator

Use and Introduction:
　　Organic waste liquid incinerator is specialised in the treatment of biochemical or physical methods can not be dealt with or inconvenient to deal with the waste liquid special incinerator, the use of high temperature (850-1300 ℃) to fully oxidative decomposition of waste liquids in the organic matter and chlorine-containing, benzene, phenols, harmful compounds, especially for high concentrations of organic waste liquids, is widely used in shipbuilding, chemical industry, pharmaceuticals, printing and dyeing, papermaking, electronics and other industries.
The structure and characteristics of LINJI organic waste liquid incinerator:
1, the furnace chamber micro-negative pressure design, the procedure of automatic interlocking control (such as ignition starting furnace before blowing, to exclude explosive gases; with a flame detection system, once the furnace chamber occurs in the fire or ignition failure, immediately and automatically cut off the oil or natural gas road, waste liquid supply), high combustion safety.
2、High degree of automation, all-round online detection and control, stable combustion.
3、Using dual-fluid pre-mixed atomising spray gun, spraying extremely fine foam droplets, increasing the specific surface area of waste liquid in the high temperature area of the furnace, to ensure that the waste liquid in the furnace rapid gasification, oxidative decomposition.
4, the use of tangential combustion atomisation device internal mixed two-fluid atomiser, the degree of mixing, atomisation effect of combustion speed is very high, low excess air, can save a lot of fuel.
5, vortex effect is good, combustion retention time of more than 2 seconds, combustion without dead ends.
6、Waste oil, waste liquid, waste solvent treatment at the same time, waste to waste, low operating costs.
7、Low nitrogen combustion technology, no smoke, no odour, no harmful gases, can burn organic waste gas and a small amount of solid at the same time.
8、According to the characteristics and composition of wastewater, the design of saline wastewater pyrolysis incinerator, to ensure that the inorganic salt incineration does not melt slag, to prevent the formation of salt spray outside the furnace.
9、Supporting perfect and reasonable tail gas treatment and purification devices to ensure that environmental emissions meet the standards.

Processing capacity: 50-5000kg/h

Treatment: low temperature pyrolysis of salt-containing waste liquid, high temperature oxidation and incineration of organic waste liquid.

Scope of application: chemical waste liquid, non-combustible high-concentration wastewater, waste acid, waste alkali, combustible waste oil, waste solvent, non-PCB and all kinds of high salt-containing wastewater.